insmod wlcore_sdio.ko 的时候出现的错误
43.767890] Powering on wl12xx
[ 143.846003] Powering off wl12xx
[ 143.849249] Powering on wl12xx
[ 143.949008] wlcore: ERROR could not get configuration binary ti-connectivity/wl18xx-conf.bin: -2
[ 143.960629] wlcore: WARNING falling back to default config
[ 143.967443] add wake up source irq 108
[ 144.292965] Powering off wl12xx
[ 144.319907] wlcore: loaded
[ 144.325471] wlcore: driver version:
[ 144.332153] wlcore: timestamp: Mon May 25 19:56:12 2015
[ 228.991855] Powering on wl12xx
[ 229.329532] wlcore: firmware chunk too long: 1731433
[ 229.334802] Powering off wl12xx
[ 229.361806] Powering on wl12xx
[ 229.653852] wlcore: firmware chunk too long: 1731433
[ 229.659057] Powering off wl12xx
[ 229.691803] Powering on wl12xx
[ 229.983832] wlcore: firmware chunk too long: 1731433
[ 229.989046] Powering off wl12xx
[ 229.992057] wlcore: ERROR firmware boot failed despite 3 retries
[ 250.011866] Powering on wl12xx
[ 250.305219] wlcore: firmware chunk too long: 1731433
[ 250.310490] Powering off wl12xx
[ 250.341847] Powering on wl12xx
[ 250.635159] wlcore: firmware chunk too long: 1731433
[ 250.640424] Powering off wl12xx
[ 250.671848] Powering on wl12xx
[ 250.963833] wlcore: firmware chunk too long: 1731433
[ 250.969041] Powering off wl12xx
[ 250.972052] wlcore: ERROR firmware boot failed despite 3 retries
看了一下，原来都不会出现固件太大uc问题，估计是拷贝固件的时候固件的数据出错导致
的
后面对比了一下固件。发现真的是不一样了。 所以重新拷贝了下就可以了。